Selecting the right cooling wattage (300 W, 600 W, 2,000 W, or 4,000 W) is only the first half of thermal engineering for an outdoor network cabinet. The second half is matching the electrical power feed (110–120V/60Hz, 220–240V/50–60Hz, 380–415V 3-phase, or 48V DC), accounting for compressor startup inrush current, and sizing winter PTC heaters to prevent morning dew-point condensation.
Every OD-Series enclosure is built to NEMA 250 / IEC 60529 IP55–IP65 outdoor thermal enclosure and EIA-310-E 19-inch mounting standards; thermal test sheets available per project.
Cooling Capacity, Electrical Input & Voltage Selection Table
| OD-Series Model | Cooling Capacity | Typical Electrical Draw | Recommended Power Input | Typical Winter PTC Heater |
|---|---|---|---|---|
| OD-12U-AC300 | 300 W (1,024 BTU/hr) | ~180 – 220 W | 110V/60Hz, 220V/50Hz, or 48V DC | 200 W – 300 W thermostatic |
| OD-24U-AC600 | 600 W (2,047 BTU/hr) | ~310 – 380 W | 110V/60Hz, 220V/50–60Hz, or 48V DC | 400 W – 600 W thermostatic |
| OD-32U-AC2000 | 2,000 W (6,824 BTU/hr) | ~780 – 950 W | 220–240V/50–60Hz preferred (110V/60Hz or 48V DC opt.) | 800 W – 1,000 W thermostatic |
| OD-42U-AC4000 | 4,000 W (13,648 BTU/hr) | ~1,450 – 1,800 W | 220–240V 1Φ or 380–415V 3Φ (Dual 2×2000W opt.) | 1,200 W – 1,500 W thermostatic |
When to Choose 110V vs. 220V vs. 48V DC
1. 110–120V / 60Hz Single-Phase (North American Roadside & WISP Pads)
- Best Fit: OD-12U-AC300, OD-24U-AC600, and OD-24U-HYB sites fed by standard municipal 120V/15A or 120V/20A streetlight or traffic pedestals.
- Engineering Watchpoint: At 2,000 W cooling capacity, a 110V compressor plus an 800W winter heater and IT switches can easily crowd a single 20A circuit during locked-rotor startup inrush. Specify a dedicated Type-D (high-magnetic-trip) breaker or move up to 208V/240V whenever split-phase service is available.
2. 220–240V / 50–60Hz Single-Phase (Recommended ≥ 2,000 W)
- Best Fit: OD-32U-AC2000 and OD-42U-AC4000 across North America (208V/240V split-phase), Europe, Australia, Middle East, and Asia-Pacific.
- Engineering Advantage: Doubling line voltage halves operating current—cutting voltage drop on long underground conduit runs across solar farms, highway medians, and mining haul roads while aligning cleanly with 208V/240V enterprise server PDUs.
3. Direct 48V DC Compressor Power (Off-Grid & Battery-Backed Telecom)
- Best Fit: Remote WISP towers and cellular repeaters powered by 48V DC rectifier plants and LiFePO4 battery banks.
- Engineering Advantage: Variable-speed 48V DC compressors draw directly from the DC bus during grid outages with soft-start ramp-up—zero inverter conversion losses and zero inrush spikes.
Heating Strips & Active Dehumidification Setpoints
Cold nights and humid coastal mornings cause just as many outdoor hardware failures as summer heat waves:
- Condensation Control: Closed-loop air conditioners naturally dehumidify internal cabinet air during cooling cycles, routing water out through a one-way drip trap. In cool, humid seasons when the compressor is idle, a thermostatic PTC strip heater holds internal cabinet air 3–5 °C above external ambient to stay safely above the dew point.
- Deadband Programming: Configure a minimum 10 °C deadband between heater cutoff (e.g., +12 °C) and compressor start (e.g., +28 °C to +32 °C) so heating and cooling never fight each other.
- Battery Freeze Protection: Lithium iron phosphate (LiFePO4) cells must remain above +5 °C during active charging; dedicated lower-bay PTC heaters protect battery warranties in northern winters.
Confirm Your Site Power & Thermal Plan
Calculate your exact cooling capacity first in our Outdoor Solar Heat Load Calculator, review solar shielding in the Double-Wall Solar Heat Gain Guide, or send your site voltage, IT load, and postal code through our 15-Minute Formal Quote Brief.
Standard & Custom-Engineered Models
12U Pole/Pad Mount + 300W Micro-AC
Compact 12U double-wall solar-shielded cabinet pairing a 300W (1,024 BTU/hr) closed-loop compressor AC with heavy-duty pole/wall/pad brackets for WISP relays and campus fiber nodes.
Full Datasheet →24U Double-Wall + 600W AC
Balanced 24U pad-mount double-wall cabinet combining a 600W (2,047 BTU/hr) closed-loop air conditioner with a segregated lower 48V battery bay for WISP distribution hubs and roadside ITS.
Full Datasheet →Flagship 32U Double-Wall + 2000W Industrial AC
Flagship 32U double-wall solar-shielded enclosure pairing a high-ambient 2000W (6,824 BTU/hr) closed-loop industrial AC with full-depth 19-inch rails for dense ITS, solar-BESS, and mining edge compute.
Full Datasheet →